Show/Hide Analytics on Model

Show/Hide Analytics on Model

All analytics can be shown or hidden on the model using the eye icon that appears next to the item in the side panel.  When item is hidden the eye icon does not appear unless you hover the mouse over that item line and it appears as an empty eye.  See an example below.




Clicking in the eye icon will show the item on the model as shown below, and the eye icon changes to full and stays on the item line until it is clicked again to hide it.  See below.

 


It is possible to hide all items by clicking on the “Hide all” icon, which appears only when there is at least one shown item.



Additionally, if several items are grouped together, the whole group can be shown or hidden as shown below.

    • Related Articles

    • Grouping Analytics

      Analytics can be bundled in groups when added or later by editing the item and assigning it to a group.  The same group may include any type of analytics including actual analytics such as cross sections, measurements such are volumes, and ...
    • Measurements and Analytics Tools

      In this tutorial, we introduce you to using measurements and analytics, how they are done, and where they are saved. We show you how to make a comparison between models and design, to run cross-section, volume, and elevation reports. Finally, get a ...
    • Importing an External Model

      Introduction External models are models generated by systems or software other than DatuBIM. To import a model into DatuBIM, the external model must consist of a point cloud file and an orthophoto file. Importing a new external model consists of the ...
    • Top View of Measurements and Analytics Tools

      This article explains in general all the analytics options that can be done and added to flights.  Three main analytical tools are available: A.    Measurements – Measurements may be done on the opened flight instance of the site. B.    Analytics – ...
    • Adding an Analytics Object

      As an example, we will add cross section progress object related to line analysis.   In general the same flow applies to all other analytics.  To add the cross section progress follow the steps below: A.    Click the line analysis tool bar (  ), and ...